Installation Instructions

Shaft Installation Guide

Each shaft is designed to be compatible with standard lacrosse heads across major manufacturers. Because head designs vary in how mounting holes are positioned, a precise fit is best achieved at the time of installation.

What’s included

Each shaft comes with:

(1) 7/64” drill bit
(2) #8 × 5/8” mounting screws

These are intended for final head installation.

⸻

Before you begin

Check shaft length first

If you need to shorten your shaft, do so before attaching the head.

Always cut from the top (non-butt end) to maintain proper fit and balance.

Take your time and ensure the cut is square for best performance.

⸻

Installing your head

Slide your lacrosse head onto the shaft and align it in your preferred position.
Hold the head firmly in place and confirm alignment.
Using the included 7/64” drill bit, carefully drill pilot hole through the head’s mounting hole and into the shaft.

Go slowly and keep the drill straight
Do not over-penetrate deeper than necessary

Insert the provided #8 screw and tighten until snug.

Do not overtighten
Snug + secure is sufficient for a solid hold in hardwood

⸻

Notes on fit

Different manufacturers position mounting holes differently—this is expected.
The pilot-hole method ensures a tight, custom fit every time.
If you ever replace the head, you may need to re-drill a new pilot hole.